Does everything look good with the Rear Baffle & New Bolt handle camming? Does your rear baffle have a set screw for the small bearing balls? If so, make certain it’s not over tight. Does the Baffle spin normally on the bolt body? The cocking piece pin doesn’t add to bolt lift in any way. Is there any material obstruction in the new barrel, causing the bolt head to hang up. No, the trigger has no bearing on it, only the Sear/Bolt Release, as it pulls the cocking piece pin back.
Are you using a Lift Kit? It’s odd that some 110’s are lighter/heavier than others. But also, just changing parts can can Increase/Decrease bolt lift just by a type of tolerance stacking. Perhaps yours was under that threshold before, but now may benefit from a Lift Kit.
These are the tough ones. Unfortunately we can’t see it in action.
Bookmarks