Started with a 10BA Stealth in 6.5CM, sold the chassis. got a 12 VLP with a DBM open bottom and a factory Savage DBM out of a accustock for the AICS mags. bolt pattern is 4.4" the issue is the DBM metal is not sitting deep enough in the stock and it appears I can fix ti by just removing one shelf of material. Everything appears to be the same level distance "lower" (when upright) than where it should be and it looks likes it can get corrected by removing the steps "shelves" I highlighted in red taking it down to the green.

Can anyone confirm if I am on the right track? or do I need to do something else

The bottom metal came from a Accufit Accustock 110 Tactical
















Here you can see how low the mag sites in the locked position.




The bottom metal is two piece all metal trigger guard and all metal magwell plate. The is the topside of the plate (side that faces stock)