To revive the thread...
I was initially quite confused about timing my scope:

When I installed scope measuring gaps under the scope cube, both reticle and clicking were significantly canted. I had to time the scope in the rings a LOT to get clicking vertical.

But then, I changed the original EGW non-canted base for Weaver 20MOA base I've read a lots of "great for the price".

To my surprise, having leveled both action and new base, putting scope+rings back on top - the scope was obviously canted to the opposite side.

After I timed scope in rings to vertical axis (now even the gaps under the scope cube are equal) I verfied on the range proper clicking.

This means that the original base was tightened VERY much to the side of the reciever, so I had some side offset of the scope.
My bad - I should check base level (and torque) first.


Anyway...

Today, I took the stock off and adjusted trigger to the lowest possible settings.
Haven't found any torque specs in the user manual, what torques do you use for tightening action in?

Found this - have anyone tried this method?
http://www.accurateshooter.com/techn...torque-tuning/

Thanks!