Captain...
I have 2 LRPVs with the HS Precision and while "hard" to find, the information I have (and works - for me) is the following...
Torque the action screws from front to back at the following values:
[Front] ...then.... [Back]
35 inch# 35 inch#
40 inch# 40 inch#
50 inch# 50 inch#
60 inch# 60 inch#
65 inch# 65 inch# <<< (this set is optional) >>>
HS Precision recommends 60 to 65 inch pounds torque. Savage will never tell you to go more than 25-30 inch pounds; that is their standard answer on all stocks (except for their Mark II / 93 series).
I have followed this procedure and it works (for me). I stop at 60 inch pounds.
There are folks who will suggest differing torque values front to back (and at around 45 inch pounds) to achieve optimum accuracy. I do not know if this applies to the HS Precision stocks as they have the AL bedding block. I may try it one day to see - but the LRPV is so accurate to begin with that I don't think I will be able to definatively say one way or the other...
The rear trigger gaurd screw does not have a torque value. I would not go beyond 25 inch pounds myself.
Bookmarks