I am sure this has been asked a couple hundred times already. i have put my stevens 200 SA CF into a new boyds laminate stock. I would like to do a bedding job on it (my first attempt) i would like to install some pillars in it as well. is it beneficial to install a pillar on the rear screw since it is almost half exposed? not much room for anything around the rear screw area. i assume i will need to ditch the magazine "L" clip as well or cut the pillar to stay below the clip? should i just epoxy bed it with out the pillars or just pillars or both? what would you do?? thanks for any input on this one