The retaining pin is aprox .060" in dia. You can use a finishing nail, around 17 ga. depending on what you have access to.
Hiya Guys
needing a little help on this. Does anyone out there know the dimensions of the ejector retaining pin on the Savage bolt face. It got damaged when I was trying to fix an ejector issue. I am based in Australia and Savage gun parts seem to be harder to find than I had imagined
I intend to either machine a piece down or if possible get a few steel dowel pins from one of the fasteners and engineering shops.
thank you
Paul
Last edited by Rouser_00; 04-03-2024 at 10:58 PM. Reason: Poor spelling correction
The retaining pin is aprox .060" in dia. You can use a finishing nail, around 17 ga. depending on what you have access to.
"As long as there's lead in the air....there's still hope.."
Bookmarks