Ok, yeah… I was thinking that. Well, I’m sure you already know that set screw needs adjusted to maintain the Bar staying level & parallel to the Trigger. Also, one thing I’m wondering: the Pre-Accutrigger Actions don’t have that tiny hole drilled for the leg of of Accutrigger spring, huh? (Photo of the spring on Accutrigger below) Did you drill a hole? Is the spring just resting against that leg not in any hole?

I circled the vertical leg that inserts in the hole. If you don’t have that hole, it could be the answer as the spring is being further preloaded & likely not very consistent.