Problems after bolt handle swap

[Hoodie]

I did move to a bigger bolt handle. But after the issue popped up I went back to the original bolt and it still happened.

I have the accutrigger adjusted as light as it will go per the instructions and I've heard that can cause slam firing issues. I'll try setting it a little heavier. Just weirds me out that the issue never occurred until I swapped the bolt handles.

Thanks for the response.

[Dave Hoback]

I’m thinking you adjusted the ACCUTRIGGER as light as possible at the same time, huh? That’s the problem. When adjusted to the lightest point, the trigger/sear surfaces do not have enough preload to keep from tripping upon closing the bolt. Adjust it a little heavier and it will be fine.

[Nor Cal Mikie]

(I did move to a bigger bolt handle. But after the issue popped up I went back to the original bolt and it still happened)

You just eliminated the bolt handle as the problem.