I got enough done to get the action sitting in the receiver. I cut the slot for the recoil lug and chamfered the FCG step to clear the accutrigger sear before cutting the finger hole for the trigger.

I used the tapered edge of a long #3 centerdrill for the FCG chamfer, they aren't just for spotting holes you know. :-)



After drilling two holes through with a 3/8" drill bit I used a 1" drill bit for one end (hole) of the trigger guard and plunged a 1" endmill through the other one. The holes were too close together to use the 1" drill bit on both of them. After drilling to 1" I used a boring bar to open both holes to 1 1/8".



The action fits very tightly in the block (without screws), I can pick the receiver up and it takes the block with it. No bedding necessary on this stock!