I don't know a lot of terms but the pictures show it all. The thin washer looking piece between the two parts looks to be bent. I never noticed it before, and there is a little give in that area. I was having trouble chambering my loads last time at the range. They needed quite an extra push forward to get the bolt to close. The rounds were loaded longer than before but using a brass rod I believed to have discovered that my mag is the limiting factor by quite a bit. Savage 11 trophy hunter xp in 260. The gun is only a few months old. I tried chambering an older dummy round and it seems fine. I'll have to try my newer dummy round tomorrow, but either way that piece looks bent and there is a springing action in that separation.





Sent from my Galaxy Nexus using Tapatalk 2