OK, this thread had been the first thing on my mind when the new Cabelas opened here in Marysville (north of Everett, Wa) and I saw one of these and I put it on layaway and now I have some questions:

Officejet - where did you find 220gr cast boolits? The lightest mold I've found is a 260gr GC design from NEI. Also, nobody makes gas checks for .366/9.3mm but on some boards they talk about crimping 375 - IF you can find a .366 sizing die or have it made.

Otherwise, Graf & Sons has Prvi brass & bullets for quite reasonable (I doubt I use this to drive tacks) which will wind up being cheaper I think than all the specialized casting equipment for it.

I'm pretty sure I'll be the coolest kid on my block either way...