Numrich might have some schematics.
I don't have any Axis on hand but was thinking about designing a 3D printable bullpup conversion for a friend. He should realize it's kind of impossible to design a stock conversion for something I don't have sitting in my office.
Does anyone know where I would find a CAD model or raw schematic of the factory stock mounting points?
I figure it would be a too-tall an order to have someone measure their gun for me and draw it out...
Numrich might have some schematics.
I'm kind of shocked someone doesn't have some of these sitting on their bench somewhere..........
The Dunning-Kruger effect is alive and well.
Action Dia. 1.350''
Receiver mounting screws 4 25/32" between centers
Length of mag box 5 17/64"
Front of receiver to center of mounting screw 1"
Action length 6
Trigger Bracket adds 2" overall
Here are some measurements from my notes, good luck.
Bookmarks