Accu stock recoil lug no idex tab?

[Dave Hoback]

I had this conversation with James at NSS the other day, I tried to drop my M12 barreled action in factory forum into my ACCUFTIT stock and it would not go in, was just doing this to check receiver bolt spacing for a new MDT Oryx Chassie, the bolt spacing is the same, but the recoil lug would not go into the slot in the bedding block, James told me they were the same lug, but he also told me the recoil lug that came on the barreled action that came out of the ACCUFIT stock that recoil lug has to be used to fit the action back into that stock, so according to James if you re barrel that action you need to use that lug, at the time I did not look at lugs to see why it would not fit, I'm fitting new stocks to both my M12 and 110SA so both barreled actions are going to have new barrel lugs to better fit the MDT stocks, I can look again if anybody wants me to?

Here’s an aftermarket taper lug like the original 110 Recoil Lug.


Here’s an aftermarket PTG non-tapered Lug.


And this is the factory Accu-Lug.