110 Hunter - Little washer, where does it go?

[Brydawg512]

Trial and error is where you are since you lack confidence in a very knowledgeable gunsmith.

Install it where you want. Check function of mag catch/release and bolt operation. Problem, move washer to a different location. Test again. Problem, move washer etc...etc....

My intentions were not to doubt anyone's expertise. I apologize as I am new to this forum and don't know everyone's background. I will follow what sharpshooter has advised.

[Robinhood]

My intentions were not to doubt anyone's expertise. I apologize as I am new to this forum and don't know everyone's background. I will follow what sharpshooter has advised.

LOL. That does sound kind of nasty doesn't it. Really though. That crusty old bastage knows a thing or 3. If he is wrong though trust your gut. It goes somewhere and I bet you can figure it out. Trial and error man. It will improve your troubleshooting skills.

[Brydawg512]

Understood! Yes I'll give his expertise some credit and try what he said.. if no luck... it will be back to the drawing board

[Brydawg512]

LOL. That does sound kind of nasty doesn't it. Really though. That crusty old bastage knows a thing or 3. If he is wrong though trust your gut. It goes somewhere and I bet you can figure it out. Trial and error man. It will improve your troubleshooting skills.

Understood! Yes I'll give his expertise some credit and try what he said.. if no luck... it will be back to the drawing board

[oley55]

Brydawg512,

do you have any feedback on the stripped front action screw problem?