Apologies for the delay jkv45. Although I did my own, I would never recommend modifying the spring. As for the cocking piece ramp, this needs a high degree of caution. I only know my own machining abilities & trust them. I will say only you can make the decision, but I always recommend to only do what you KNOW you can, based on your mechanical inclination.
Setting the pin .080” from the edge at bottom travel is accomplished by unscrewing the cocking piece from the firing pin. Doesn’t take much, and use a caliper to get the distance.
Here is a good picture showing the ramp. What I did was soften that “nub” on the corner, & polish the edge(as indicated). And it’s paramount to understand terms like “polish” & “soften”. Any form of metal removal can quickly lead to trouble.
Bookmarks