Problems getting enough elevation Something's not right

[gr8lakes]

Just a note

I have 2 savage .308 rifles, an 11VT from Dick's, and an 10 FCP-SR that I just got a few weeks ago.

On the 11VT I have a weaver 20moa rail with a 32 power scope,
when I received my 10FCP-R I wanted to get out to the range fast
so I removed my scope and base from the VT and placed it on the FCP-SR.

I needed to adjust the scope 11 moa just to be on center between the 2 guns.

So yea something is different with the receiver on the 10FCP-SR.


Edit:

I only had 36 moa left with the 10FCP-SR from 0, I will remount the rail and scope on to the 11VT, and post this weekend if there diffidently is a 10 or so moa difference.

[Bimmer]

I needed to adjust the scope 11 moa just to be on center between the 2 guns.

So yea something is different with the receiver on the 10FCP-SR.

You didn't say whether you went UP 11 moa, or down, or to the left or right...

FWIW, I had my Nikon monarch zeroed on an AR at 200yds, and then I mounted it on my new FCP-SR.

To zero it on the FCP-SR (also at 200yds) took 32 clicks (8 moa) UP from where it was.