I just received mine recently from Anthony off another forum. I spoke with him quite a while on the phone before ordering. I thought I made it pretty clear I was hobbyist and not a gunsmith. I also told him I was military and didn't have a workshop. He assured me it was OEM and would drop in. Well, the fit and finish are pretty good except the bottom of trigger guard was scuffed up, it is matte black. Unlike the CDI,this is 2 pieces with trigger guard overlapping the bottom metal. In my case with a 10 FCP and Tupperware stock the pieces didn't line up properly. I sent several emails on different forums and he finally answered this weekend. He said it was OEM and that I should get a competent gunsmith. Needless to say that DIY was the whole point of this exercise. I have built several AR15 type rifles and chose to go with Savage for the DIY aspect. So unless I find a gunsmith in the El Paso or Las Cruces area, I can't use it. In addition, I bought two of their magazines, a 5,10 round. I must say I liked how they snapped into the BM. I haven't used them yet but was very pleased with the magazines. I know they were a GB on SH recently, so you might get good feedback from there.
Bookmarks