I did find where the front action screw was not pulling the action down to the pillar block even when tightened. After several times of taking the stock off and on checking for witness marks and running a feeler gauge and dental floss between the action and pillar. I filed the DBM where it was contacting the bottom of the flat part of the full length aluminum bed. I filed it down until only the square surrounding the hole was all that was contacting the piece of aluminum. Reassembled and could not pull my piece of dental floss between the pillar and action or insert my small curved feeler guage either. Took it out to shoot and an immediate improvement. I had planned to take some pics but my buddy came by and I returned his inch lb torque driver to him so I don't want to take the stock off again without it. Sorry.
Take the DBM out of the stock and where the front action screw goes throughthere is a square this seems to be the only metal you want to tough the aluminum bed.

Thanks for the tip!