Quote Originally Posted by trappst
You may need to remove more material at the notch on the ejector. It sounds like the case is being extracted but it's losing pressure against the raceway as it comes out.

By lengthening the notch in the ejector, you're increasing the pressure the case can put on the raceway. Thus, the case stays on the bolt head till it clears and can be tossed out.

It'll prolly be a trial and error type deal...remove a little at a time and test it out until you get reliable ejection.

If you look at this picture, that sharpshooter posted on the ejector thread on the small end of the slot to the right, I have filed almost to where the bevel begins. any further& I will be losing material to retain it in place. ???