Yes, that works just fine.
Ok, I just built a 6br and it ejects about 1/5th of the time. I was wondering if I just removed the ejector if the bolt would just hold on to the case so I could just reach in and grab it?
Yes, that works just fine.
"Muzzle velocity is a depreciating asset, not unlike a new car, but BC, like diamonds, is forever."-German A. Salazar
Not only does it work just fine but it keeps the rifle from throwing that Lapua brass in the dirt next to the bench. All of my bench guns have the ejector removed.
Well sounds like a win-win situation. I just hate when it drops the case before the port. Thanks guys.
But that's how I find all my free Lapua brass at my local range. ;DOriginally Posted by Samdweezel05
"Muzzle velocity is a depreciating asset, not unlike a new car, but BC, like diamonds, is forever."-German A. Salazar
You wouldn't find much of mine, I'm a super freak about my brass even shooting pistols.
Ok I just looked at my bolt and I don't know how to take the bolthead off. Do I pound out that black pin?
No need to pound on it, just press the bolt-head down with your thumb (takes the pressure off the pin) then with a punch you can push the pin out,(or give it a light tap) now this is done after you remove the bolt assembly screw, and firing pin assembly.
Curt
WHOA ! The EJECTOR is the spring loaded rod on left side of the bolt that pushes on the base of the case causing it to eject when the case clears the port. It can be removed w/ a 1/16" punch by pushing the pin out. However, it sounds like you're talking about the EXTRACTOR being the problem. ( It only ejects 1/5th of the time ) The extractor is on the right side of the bolt & has a little claw that grabs the extractor groove of the case & draws it from the chamber. If, as you said, You're only extracting 1 out of 5 cases removing the extractor isn't going to improve anything. Removing the ejector isn't going to help either. Take your rifle & some brass to a Qualified Gunsmith & let him analyze the problem before you cause yourself some BIG headaches. JMHO
I agree with gotcha.You can remove the ejector,but if the xtractor isn't holding the brass,I would calll customer service and have them send you a couple new extractors.Common problem with many target actions.
If the extractor doesn't grab enough of the rim the fix for that is putting a larger diameter detent ball under the extractor. If there's nothing wrong with the lip of the extractor you can change them till you're blue in the face and nothing will change.
Some cases have less 'lip' to grab and are extraction sensitive.
+1....... What Scott said. The thickness of the rim as well as the diameter of the rim come into play. Pull the bolt, cinch it down in a padded vise vertically & force a case into the bolt face. Have a lot of movement? Extractor fully engaging the rim? You might only need to change brass :D
My bolt heads must be broken. All of my extractors are on the left side. ;DOriginally Posted by gotcha
"Muzzle velocity is a depreciating asset, not unlike a new car, but BC, like diamonds, is forever."-German A. Salazar
That's 'cause you're holding the rifle upside down ! ;D
I think you guy's are putting words in his mouth.Originally Posted by ICUDIEN
He is speaking about the ejector, not extractor.
Curt
Their point is that poor ejection can be a result of loose fitting bolt head and/or a marginally working extractor.Originally Posted by Netz
"Muzzle velocity is a depreciating asset, not unlike a new car, but BC, like diamonds, is forever."-German A. Salazar
Bookmarks