Here ya go
« Reply #5 on: January 18, 2011, 09:01:46 AM » Quote Modify Remove
--------------------------------------------------------------------------------
Hi the way I unload them I feel is very safe, all you have to do is put the round in the proper shell holder in your press "remove dies" then bring the round up to where the bullet just sticks out past the threads where you screw in the dies, clamp the bullet with wire cutters or pliers I use a cable cutter hold lightly you don't need a lot of clamping pressure not to mar the bullet "two slight dimples is all you should have more than that you are clamping to hard" and bring the handle back down slowly and smoothly, a press has a lot of leverage so no brute force is needed, it doesn't take long to get the hang of it and you will be able to reuse all of the componets, I use the powder and bullets when I am fireforming my latest AI barrel. I preffer this method to they hammer bullet puller, it just doesn't seem natural to whack a loader round in a hammer and my way you can do 10 in the time you set up to do one the hammer way, and the best part no violent whacking just a smooth cycle of the press. as allways re loaders take care or in this case "unloaders"
Thanks Dean
Bookmarks