Matt,
Do you mean you skim bedded the action to the v block? that was it, right? Please correct me if i'm wrong here...never done any rifle bedding work before.
take the action out
drill a few small holes into the v-block
put on neutral color Kiwi shoe polish on the bottom of the receiver, the back of the recoil lug, in the action screw holes, and on the action screws themselves
put on a THIN layer of Devcon (any recommendation on what kind? Can I buy it from the local Home Depot or OSH hardware stores?) in the center of the aluminum blocks ONLY
Put the action on top, insert the action screws, tighten it up so that the action stays put, but not super tight?
After a day or so, take it out and let it cure for another day or so
Put it all back together?
Bookmarks