I don't know anyone who has had an issue. Could have been an error. Most people say the trigger pull weight is not low enough. Send it to me and I will test and return it with my analysis.
So I purchased the ElftMann Savage trigger from Buds Gun Shop about a week ago. After the first 20 rounds, it worked perfectly, even following the Youtube video recommending checking for debris. Rounds 21 and 22 while rechambering a round fired. Thinking it was my fault, I adjusted the rifle to its maximum pull weight another accidental discharge. I contacted Elftmann there response was that it could be an old design. Please send it in for a replacement. Not to mention, they have never heard of Buds Gun Shop I personally believe the trigger design is flawed with such a weak spring. I wonder how many generation of the trigger are floating around. I did ask the manager/owner to reach out to me. I honestly just went back to the accu trigger. If anyone else has had trouble, do you know a solution? I'm all ears?
I don't know anyone who has had an issue. Could have been an error. Most people say the trigger pull weight is not low enough. Send it to me and I will test and return it with my analysis.
The Dunning-Kruger effect is alive and well.
I put this trigger in 3 rifles. One started getting slam fires off the bench. When i put a trigger pull gauge on it, it was way lower than i set it. And was also all over the map, and adjusting the screw wasnt doing anything. Took it apart all the way, wiped it down, reassembled, good to go. Also ive had to screw with them a bit to get the 3 stage safety functioning properly. So theyre not exactly a set it and forget it deal, but with a bit of messing around all of mine are squared away and i have no desire t put the accutriggers back in.
Send me a message I'll send you some pictures of the back of the tigger and the stuck piston.
Bookmarks