Quote Originally Posted by Rocketvapor View Post
Dave, I'm sure you have already discussed the better fit of your cocking pin.
Could you point me to the discussion?

Oh, it wasn’t a discussion on that. Art made a thread about his PTG bolt sleeve and it came to be he has an older factory bolt without the lower section like newer bolt sleeves have. He needed the Cocking Pin with a higher head. I had offered him my factory pin if he wanted to wait until I had finished the Ti pin I had already started on. But I linked the correct part from Numrich which he ordered. And during that, I finished the pin I was making.

Here is the thread.
https://www.savageshooters.com/showt...-G-Savage-bolt


It’s no biggie. I just measured and went a little heavier in spots. Got rid of the large amount of wiggle the factory pin had in the Cocking Piece. It fits easily, but snug now.