Sounds like a winner! As for the dies and bushings I would get a neck sizer and a body die. Neck size until you start to have problems chambering loaded rounds then run them through the body die, I have that combination in .264 WM and it works great. The bushing you need will depend on the neck diameter of loaded rounds. I like to size the case neck on my target shooting ammo to give a .002 bullet pull, hunting ammo I like a little more neck tension on the order of .003 - .004. Measure the neck of your loaded ammo with an accurate micrometer and subtract to find the bushing size you need.

Hope this helps.

Bob