Welcome. Firstly, this is the wrong spot to post this. You should ask and see Fiona of your model 12 in the 10/110 forum section. One of the Moderators will likely move it there.
Hopefully you are driving from the correct side? The pin is splined and come out/goes only from one side. This article explains and shows the correct way. https://www.savageshooters.com/conte...Removal&page=2
We see see these fairly often. And like those, my guess is you drive the pin the wrong way which essentially “locks” the pin in. Sort of like stripping a bolt. You could try a 1/16 blunted drill bit as a punch being it’s shorter it will have greater rigidity. Although careful of it breaking. Worse case scenario, it may need drilled.
BTW: It’s not necessary to remove the ejector in order to measure CBTO. What method are you using?
Bookmarks