Quote Originally Posted by P Flados View Post
In recent decades, my 30 Herrett shooting has all been IHMSA focused.

Back many decades ago, I remember my 10" (bull with the permanent front sight) was real happy with H4198 and a 110 gr bullet.

I am sure it was either a Sierra or Hornady bullet, so my load data would be of limited use for you.

I did a Quickload table with your bullet so you can compare potential velocities and fill percentages of different powders.

Code:
Cartridge : .30 Herrett
Bullet : .308, 110, Nosler VarMag 34057
Useable Case Capaci: 31.165 grain H2O = 2.023 cm³
Cartridge O.A.L. L6: 2.320 inch = 58.93 mm
Seating depth : .204 inch
Barrel Length : 14.0 inch = 355.6 mm
C A U T I O N : any load listed can result in a powder charge that falls below minimum suggested
loads or exceeds maximum suggested loads as presented in current handloading manuals. Understand
that all of the listed powders can be unsuitable for the given combination of cartridge, bullet
and gun. Actual load order can vary, depending upon lot-to-lot powder and component variations.
USE ONLY FOR COMPARISON !
Powder type Filling/Loading Ratio Charge Charge Vel. Prop.Burnt P max P muzz B_Time
% Grains Gramm fps % psi psi ms
--------------------------------- -----------------------------------------------------------------
Alliant Reloder-10x *C 102.8 27.9 1.81 2279 86.7 34989 7993 0.865
Hodgdon H322 104.0 29.0 1.88 2230 79.7 34989 7621 0.860
Accurate 2460 104.5 32.3 2.09 2229 76.0 34989 7664 0.869
Lovex D073.5 104.8 32.3 2.09 2229 76.0 34989 7664 0.869
IMR 4198 98.0 25.3 1.64 2226 88.0 34989 7266 0.859
Hodgdon H335 98.5 30.9 2.00 2224 77.7 34989 7636 0.863
Alliant Reloder-7 93.9 26.1 1.69 2223 87.9 34989 7412 0.881
Accurate 2015 105.0 28.9 1.87 2221 84.0 33185 7679 0.887
Hodgdon H4227 88.4 23.2 1.51 2220 92.4 34989 7084 0.863
Lovex D073.4 102.1 31.4 2.04 2212 75.8 34989 7453 0.868
Lovex S053 88.6 22.8 1.48 2211 95.7 34989 6970 0.878
Alliant Reloder-12 103.4 30.3 1.96 2211 80.1 34989 7414 0.865
Winchester 748 103.8 32.1 2.08 2204 72.7 34989 7568 0.864
IMR 4227 86.8 22.8 1.48 2191 91.1 34989 6851 0.868
Accurate 1680 85.3 25.6 1.66 2187 83.4 34989 7064 0.876
Accurate 2230 102.5 31.9 2.07 2186 72.7 34989 7220 0.869
Accurate 2200 94.0 27.4 1.78 2181 78.2 34989 7080 0.873
Alliant AR-Comp *C *T 105.0 29.2 1.89 2174 82.6 31156 7773 0.900
Hodgdon Benchmark 103.0 29.1 1.89 2170 76.0 34989 7029 0.877
Hodgdon H4198 93.3 25.2 1.63 2157 81.2 34989 6726 0.875
Hodgdon BL-C2 105.0 32.9 2.13 2137 69.4 32156 7333 0.896
Hodgdon H4895 105.0 30.2 1.95 2122 69.8 31086 7159 0.910
Accurate 2520 105.0 31.8 2.06 2103 71.6 29581 7290 0.924
IMR 3031 105.0 28.2 1.83 2036 72.6 26884 6989 0.960
Just wondering….why run that table at such a low pressure? Seems like 40-45000 psi is closer to normal max contender pressures?? Do you agree?