I see lots of protrusion and a large radius. With a primed cartridge in the chamber the firing pin will protrude no more than .025" from the face of the bolt. Even if you set your protrusion at .050". The primer cup and the anvil pressed against the bottom of the primer pocket control how far the firing pin moves. Therefore the radius should cover slightly less than .025" from the very tip of the firing pin. Fred(sharpshooter) graciously posted a drawing in the link I provided above to add a visual to this topic.

The protrusion could be adjusted to allow for a the correct firing pin travel but not going to be the fix for ths particular issue.