Anyone else having sticky bolt problems with the factory ELD-M ammo? I have fired 60 rounds of factory 300 prc through a brand new Savage 110 LRH and a brand new Browning x Bolt and both rifles had difficulty ejecting spent cases. In both situations, the bolts would not completely cycle to the up position. After a delay of up to 30 seconds, the bolts on both rifles would completely cycle using stiff pressure on the bolt handle and then would allow for rearward movement to eject the empty case. No ruptured or cracked cases but every primer appear to be flattened. Firing pin indention appears normal. I spoke with Hornady, Savage and Browning and while everyone agrees they will fix any problem, they also agree it is the fault of someone else. I am preparing to reduce load some of the fully resized cases to see if the problem persists. Anyone else seeing this issue??