Quote Originally Posted by 243winxb View Post
Old post warning.

Close tolerances can slow firing pin speed. The round part can drag on the receiver. After firing, flush bolt/firing pin channel with WD 40. Or let Hoppe's No. 9 Powder Solvent run down the pin channel Before firing, lube with Break Free CLP, it contains Teflon. . I do this on both Axis 223 & 6.5 Creedmoor.

I don't know the properties of the lubricants you are using when the solvents evaporate but every time I try to lubricate any part of the bolt internals I have problems. If anything I would completely clean the inside and remove any gunk to eliminate any sluggish firing pin travel. Again, I have not studied your particular lubricant's but I have plenty of others. That has been not only my experience but many others. A dry film may be a good option.