Put the 9/64" ball in yesterday along with a new extractor and spring that I got from Savage. The case would not extract at all! I suspect that the tolerance with the larger ball did not allow the extractor to slip over the case rim? I replaced the 9/64" ball with a 1/8" ball that Savage also sent, and the cases eject fine now again. I'm an old man and forgot that I had run into this same extraction problem last year. replaced the extractor, spring and 1/8" ball then too. All worked well since last July and then the problem crept up again that resulted in my original post of 5/9/20. If this happens again, I'll try replacing the ejector spring and pin. Thanks for all the help for a feeble old man with a poor memory!