Shilen or criterion

[JW]

I have a question. I put together a 110 with a shilen select match hvy spotter 6.5x55. Boyd's at1 stock. Used some cheap ammo to shoot clean shoot clean about 15 shots. It was cleaning up pretty good. Ok went to nosler trophy grade 140 accubond factory. Hell it shot less than .5 at 100, continued to shoot less than moa at 200 and300 yards question is where do I start for reloading. Is this gonna be hard to beat, or do I start trying to beat it. 140 accubond seated to the same depth as the factory ammo?

The short answer: If your happy with the factory ammo group size, shoot the factory loads.

Reloading will typically produce smaller groups.
I enjoy working up a load for a new rifle, others might not.
A lot of variables are at work when loading for 1/2 moa or below.
The rabbit hole can be deep LOL

Back to original post:
I have both criterion and shilen barrels and I believe you will be pleased with either one.
Jack