The best thing about glass/epoxy bedding is 30 minutes with a Dremel and a carbide burr and you are ready to start over. I did my Savage in three phases. Used a drill press to open up the action screw holes and bedded aluminum posts in them with shims and masking tape to center the receiver and barrel. Then I glass bedded the action. Then I glass bedded the "bottom metal".

95% of the glass bedding job is preparation and "dry runs" before you ever mix the components.

Happily, in doing so BEFORE I bedded anything I found the rear pillar was too large to allow the sear to trip! I had to notch it. That would have been a REAL pain to correct once it had been bedded.