I've been running into problems with light primer strikers lately. Problem started after about 100 rounds thru the rifle? Not only am I getting light primer streikes from the FP but when rounds do fire I also get pierced primers! Figure that one out! My range trip yesterday was a disaster, 100 grain Interlocks over 7828ssc powder, of the 6 rounds tried, two failed to fire and two had pierced primers. Primer were pretty flat so I didn't try shooting the remaining 6 rounds. Charges are no where near the max of 44.5 grains and bullets were seated .013" OTL.

Next tried were 80 grain Sierra Spitzer BTs over IMR 4461 Max charge being 40.3 grains but my loads were between 37 and 37.6 grains, bullet .009" OTL. Six rounds fired but again showed very flat primers The next six again showed light primer strikes and would not fire. I've had it with this Axis. Talked to Savage about the problem and they said to send it in to be looked at. Did some checking with Fed Ex and UPS. To send it back to Savage is going to cost me another $65 to shipped it insured. I'm not wasting another penny on this POS. On top of all the firing problems the Weaver scope went belly up early on, elevation quit working so had to replace the scope. This will be the last Axis I ever buy.