Quote Originally Posted by jkv45 View Post
Is it worth drilling and tapping the .357 case to use a set screws with a ball that turns like the one above?
Sorry JKV45, The BAS is drilled and tapped(this is a 6mm screw) in a collet, in the lathe. It could probably be done a couple of ways but it must be on center and concentric! The flat surface is machined out of round stock to fit in the sleeve like the case does . It is kind of reverse from the pistol case setup. The stack height is very low, something like 3/32 or less. If you machine the screw back it can even be a negative number. Be careful with shortening the whole system too much. You don't want the cocking pin in the sleeves entry slot.