In the pictures on the Choate Machine site, there is no hole or inletting to accept any bottom iron, and choate does not mention offering one. (I fact there is a disclaimer about their stocks NOT working with BDM's.) Is there a bottom Iron, that would accept the center feed BDM that I already have? Perhaps better than the plastic factory stuff we have been whining about elseware on this board.

I have the means to inlet/fit it into the bottom of the plastic super sniper stock. The time to do it, as usual, is always short.

Perhaps, if enough of us ask, they will modify the CNC machine program they use to inlet, to accommodate our beloved rifle, AND all its quirks.

Paul