You already have most of the parts needed in your old setup. When you get the correct stock for your rifle take the DBM and press in on the sides near the bottom. This will release the tabs on the bottom cap from the magazine. Take the follower, spring and housing inserting into the stock blind magazine cutout. There is a small 90 degree bend bracket that you will have too get from some source. This holds the magazines rear end in the stock magazine well. The other leg of the bracket is sandwiched between the action and stock. The magazine for the WSM's is different from other cartridges such as the 22-250, 308/30-06 case heads and the magnum cases such as the 7mm Rem Mag. It's short action length based.
Bookmarks