I have some more data. This is a new 10T-SR 6.5 Creedmoor just out of the box and never yet been fired. But I'm interested or concerned already about accuracy/repeatability potential with the unorthodox accustock after reading some other threads and I was wanting to understand how the accustock secures the receiver. So I took some data on my rifle before it was ever fired. With the rifle upside down and the magazine removed, I was able to get a 0.003" paper feeler gauge between the receiver bottom diameter and the aluminum center spine (pillar). My front and rear action anchor points appear to be uneven (meaning not the same). At 10 in-lbs torque the spine near the front action screw is far from touching, and the rear is already touching. As I go up in 5 in-lbs increments all the way to 35 in-lbs, the action is indeed drawn into the stock but the front never touches and the rear is always touching. concerned with the