I can tell you the trigger mechanism touches nothing in the cadex chassis. Before going to the egg challenge today, decided to adjust the screw for trigger setting. Made sure it went all the way possible to heaviest setting. Tested it before going to range. Was able to creep it all the way without the safety engaging. To heavy for my taste but didn't want issues on the firing line. Worked. Hit egg on 1st shot with my pet load. No reply from SSS but will still consider replacing it for a lighter trigger pull. The 10T was purchased 2 years ago. Accustock and accutrigger. About 1000 rounds shot through it. Going to mess with it this week by adjusting in small steps and dry firing to see how far I can go before the safety trips on most pulls. Won't be much though as before. Set it until I can replace it. Thanks for all your comments and suggestions.