A short barrel will be equally if not more accurate than a longer barrel.
I cut a few using the brownells crowning tool with a hacksaw and file. I was very happy with the results
Sent from my SM-G930P using Tapatalk
hey guys I am thinking of getting a new barrel for my 11 build but I don't want a 26 inch barrel . I live in the north east and it will be a whitetail gun , so I am thinking of getting a barrel an getting cut down to like 22" or twenty . I know it wont be as accurate as a 26 but will mess with the overall accuracy cause I will shoot out to 200yrds at the range .
A short barrel will be equally if not more accurate than a longer barrel.
I cut a few using the brownells crowning tool with a hacksaw and file. I was very happy with the results
Sent from my SM-G930P using Tapatalk
One of my most accurate rifles had a 20" barrel. They are usually a little less prone to harmonics. You will lose some velocity, but under 300 yards it is not too much of a concern. There are plenty of DIY cut and crown videos on YouTube, and I have done some myself. If it is an option, you could always order it in the length you prefer.
A strong body makes the mind strong. As to the species of exercises, I advise the gun. ... Let your gun therefore be your constant companion of your walks.<br /><br />Thomas Jefferson
Your cut off job should be a very simple job for anyone who is a real gunsmith. If you lived near me in Central PA I could direct you to 2 good folks with in 25 miles of me.
I would not hack it off myself, but a shorter barrel is not going to be less accurate.
A longer barrel does two things. Its heavier and a bit steadier if bench rest or supported,
Just order it that length or a gun smith can do it and do it nice and clean and looks right with no mistakes.
"Ain't nothin to it"
Do a search and see how many ways people have done it successfully, and go for it.
There is even a good write up on how crowns were purposely mangled, and how little affect it had on the rifles accuracy.
I have shortened 3 barrels, using only tools in the shop, and all of them shoot better than before the cut. I didn't bother with the crown tool.
If You have doubts, just leave the barrel 1/2" long, and if You don't like the results, You can always pay a GS to do it.
True (pun) enough, I like a nice finished look.
^ Managed to get that also ;-)) ^
A shorter barrel can be more accurate, as others have already pointed out. It won't whip from harmonics as much as a longer one but you will loose some pill speed.
Bookmarks