Quote Originally Posted by ninner View Post
The axis uses a short action bolt head and you now have too much firing pin protrusion. In a jam in the past I've added stainless washers between the firing pin and bolt head to limit firing pin travel with success. I would not use it as is now you will likely pierce a primer or break the firing pin.


Sent from my iPhone using Tapatalk
I did notice the firing pin on the 111 was noticably longer then the axis firing pin. So basically in order to avoid piercing primers or breaking the pin I need a bolt head specifically for a LA or a different firing pin? I just eye called the bolt heads and they appeared to be the same size though I did not measure them however.

Sent from my XT1080 using Tapatalk