I have a spare ejector retaining pin a can measure if that helps
What is the size of the ejector retaining pin hole. I think they should all be the same. But specifically for a 223. To much headspacing has roughened the interior of the hole.
Thank you
Marlin
I have a spare ejector retaining pin a can measure if that helps
Deleted: bad advice.
The Dunning-Kruger effect is alive and well.
The retaining pin hole is .063". The ejector hole is .103", plus or minus .001".
"As long as there's lead in the air....there's still hope.."
Thanks Fred. I glazed over that one. I do use a 1/16th pin punch on the retainer pin.
The Dunning-Kruger effect is alive and well.
Thank you Sharpshooter. Now i an order a reamer to clean up the hole.
Bookmarks