i spent a ton of time on 2 axis triggers. If you look closely, you can see that the trigger machining isn't perfect. I got one to 3.5 and the other to 3.25. It seems like the best i've been hearing is 3. I'm more than happy with mine. there is zero creep. If i had it to do over again, i would probably file the shim more so the sear sat a tick deeper in the trigger groove. i think going less than 3 might be possible in that case but i'm no trigger expert. At any rate, if you take out the creep and get it to 3.5 you will be more than happy i'm sure. mine feels lighter than that but it scales consistently. Just be SURE to research all the trigger testing methods on here and test repeat test repeat etc with every change you make. I found that to be very important. Repeat all your testing once the action and barrel are back in the stock as well as this will likely change things.
I installed the overtravel hex screw, a shim made from a heavy duty paper clip, and an aftermarket spring which was very similar to the coil thickness of the stock spring.
Bookmarks