Did the issue start only after it was re-barreled? Or has it been going on since you bought it new?
It is actually very easy to check. Get a caliber specific "GO Gauge" and put it in the chamber. The bolt should close smoothly like there is no shell in there. You can then install a NO Go Gauge and make sure the bolt will not close all the way. You can also use the GO with a piece of tape on the "primer" end to do the same thing. While you are at it, check to make sure the ejector parts on the head are not damaged or sticking.
Did the issue start only after it was re-barreled? Or has it been going on since you bought it new?
[I]"In the end, run what 'ya brung because it's better than nothing and don't give two ****s what some interwebs chat board guy says about your rig."[/I]
I mean can I adjust the headspace on my own?
Yes, but you'll need an action vice (or some alternative way to keep your action in place), a barrel wrench, and a set of go/no-go gauges for .308. Barrel removal and installation is extremely easy on a Savage - plenty of well-documented info on this. Check YouTube, there are tons of how-to's.
Again, did your issue start only after it was re-barreled? If so, your issue is almost guaranteed to be headspace related. If that's the case, do not, I repeat DO NOT under any circumstances, shoot your rifle until you have the problem sorted out.
[I]"In the end, run what 'ya brung because it's better than nothing and don't give two ****s what some interwebs chat board guy says about your rig."[/I]
Did your gunsmith rebarrel it using a barrel nut? If so you can reset headspace. If he set it up like a remington then no your can not easily reset headspace. And once again did it act this way from the beginning or only after the barrel was replaced?
"And you shall know the truth, and the truth shall make you free.” John 8:32 (New King James Version)
Checked with another gunsmith, who confirmed that the headspace was good. Wonder if I should try an aftermarket bolt.
Bookmarks