This only happens when I reload for my 270 wsm. About one out of every 3 cases will not smoothly load in my rifle and the bolt is hard to push down, this is on empty unprimed cases. Only happens after I run through my redding resize die. It might be I am not lubbing the neck enough and the shoulder is getting pressed a little-- I guess, not sure. I do know this has happened even after I had trim all the cases to the same length.

This never happens on the other calibers I reload, 223, 243,308, 7mm-08.

Still fired some as I did not notice this until I had reloaded about 50 shells.. Accuracy was still good

Any ideas sure would help me save brass..

Thanks.