I just got the Accurate Mag DBM and had some fun with it. The stock action screws are both far too short for this DBM, so all that BS that people have been reporting is total internet BS. The front action screw is about an inch too short*. The kit comes with longer screws for assembly. The front one is about 1/4-1/3" too long and interferes with the bolt lug. So maybe that means it's 1/3-1/2" too long. I just know it'd have to be 1/4-1/3" shorter to stop it from hitting the bolt lug.
Also I followed the torque directions posted in this forum and it destroyed my stock. The rear screw completely stripped out the plastic stock before I could hit 10 inch pounds, and the directions posted say to go to 40-45 inch pounds in 10 inch pound increments.
So the DBM doesn't work and the stock is ruined. Hoo-the-****-ray. I love this industry. Wrong gun, wrong screw, wrong directions. Just bend me over and stick whatever you want up there.
*edit, I measured and it's only 0.6" longer.
Front screw
Savage: 0.821" (too short to reach receiver)
AccurateMag: 1.411" (too long, blocks bolt)
Middle screw
Savage: 1.630"
AccurateMag: 1.9275"
Bookmarks