Quote Originally Posted by Gabe1972 View Post
Thank you. I had read 15, but I wasn't sure. I also read that if you don't have a torque wrench available, inserting the long end of the Allen wrench into the screw and holding onto the short end, if you turn it as hard as your thumb and finger can hold onto the short end, that would be about right. I think the whole idea with that was just not to over tighten and either ream out the head or strip the screws, which would be VERY bad. Thanks again for the help.

Also, have you ever used anything like this: http://www.amazon.com/Wheeler-Firear.../dp/B0012AXR4S ? Thanks.

Wheeler will last you a lifetime!