It would be easier to just make the plate in the desired dimension, then allow for the stock taper with different width spacers between the plate and stock.
I use the same setup on several of my guns. I use sections of old heavy rifle barrels for the spacers cut to proper legnth. Stacks of stainless fender washers
would work also. Long hanger nuts epoxied into the stock will hold it in place. Be advised teflon plates also work well and slide nicely. The rear wont be as easy,
and will require some fabrication. If its a wood stock an add on could be made and epoxied in place. Other type fabrication will require mounting which usally means holes.
Again, teflon would work with holes up into the bottom.
Bookmarks