That's good to know and thank you
Would like to see pictures when your done.
The guard is too big for the slot in the stock. I will sand a little bit on the plastic trigger guard rather than the stock. Only need to take off about .030"
That's good to know and thank you
Would like to see pictures when your done.
Got the barrel chamber opened up and fit today, the only problems are with the bolts-screws that hold the stock to the barrel. I put a factory DBM in the stock, the front trigger guard screw is to short and the DBM screw by the Mag release is to long. Where can I find screws for these?
Thanks
If you go back to Boyds and look on that particular stocks' page you will see they note this and sell longer screws.. sorry..
Thanks foxx and ywhic no apology needed something I over looked and should have paid more attention.
I put the rear dbm bolt on the grinder to get it to the correct length and then took the trigger guard and ground just enough off it so that bolt would fit.
Thanks for the help guys
Bookmarks