Why not convert to a standard stock with a normal recoil lug or is it to hard to get the parts you need to do this.That way you would have a nicer selection of stocks and so forth.
Alright, I have failed miserably at finding an Accustock recoil lug so I'm going to attempt cutting down standard recoil lug. I know the sides have to be cut down and it has to be shortened. Do I just cut sides down until it fits inside rail and then shorten until action bottoms out? Just got shipping notice on PTG bottom metal.
Why not convert to a standard stock with a normal recoil lug or is it to hard to get the parts you need to do this.That way you would have a nicer selection of stocks and so forth.
Willing to give back for what the sport has done for me!
I had a max-1 Accustock given to me. I bought a hog hunter and ordered PTG bottom metal for it. I've already cut out for the top bolt release in stock and just needed recoil lug. (Thought this was the easy part)
I have no intention of using this for long range and will experiment with subsonic loads mostly. If I like it I'll get a blackout for ar and if I don't I have a short barrel 308.
I have a lug I got from Jim last week but I will try the factory one first. Knowing me I'll wreck the free stock if I cut the sides.
Jetpig, rather stupid question, is that aft from front of stock or back. Picture threw me off and I couldn't make it out. Aft depends on where your standing if I'm thinking right..it wouldn't be the first time if I'm wrong.
Bama1, he means leave the side of the lug closer to the action alone. It should fit square / true against the rail so it does not want to push the barrel to one side or other under recoil.
Thank you, foxx.
Bookmarks